Automatizzazione al solo tocco di un tasto
Troubleshooting
The pictures used in this section may not look exactly like your robotic cleaner but troubleshooting procedures should work with your cleaner!
9. Preventive maintenance:
- Clean robot weekly!
- Remove robot from the pool and place near a water hose
- Remove the bottom lid and filter bag
- Empty filter bag, turn it inside out and clean filter bag thoroughly with high pressure hose
- Spray the outside of the robot and remove any debris
- Turn the robot over and spray the inside of the robot, brushes, lock tabs, shaft and bearings
- Install the filter bag and reinstall on bottom lid
- Position the Grommet holes so they are at each end of the wire forms. The blue label should be located in the middle of the long side of the bottom lid.
- Install bottom lid back into the cleaner
- Push in the bottom lid until all the tabs are securing the bottom lid to the Robot’s body
- Weekly cleaning of your Robot will extend the life and keep it looking like new
- Your Robot is now ready to clean your pool
